N900 Hardware Hacking/serial dump

NOLO X-Loader (v1.4.14, Apr 22 2010) Secondary image size 109384 Booting secondary [ 0.002] Nokia OMAP Loader v1.4.14 (Apr 22 2010) running on Nokia N900 F5 (RX- 51) [ 0.014] I2C v3.12 [ 0.033] System DMA v4.0 [ 0.036] OneNAND device ID 0040, version ID 0121 (256 MiB, 66 MHz) [ 0.071] OneNAND blocks unlocked in 28052 us [ 0.075] Flash id: ec4021 [ 0.094] Partition table successfully read [ 0.102] TWL4030 PWR ISR: 40 [ 0.105] Reset reason: por [ 0.107] McSPI v2.1 [ 0.111] LP5523 found at I2C bus 2, address 0x32 [ 0.121] SMB138C: Not loading driver (version reg. 0x4b) [ 0.127] BQ24150 (rev. 3) found on I2C bus 1, address 0x6b [ 0.133] SSI version 1.0 [ 0.147] Battery voltage 3.436 V, BSI: 0 [ 0.157] Disabling charging (no battery present) [ 0.169] Initializing LCD panel [ 0.172] Detecting LCD panel moscow [ 0.176] Panel ID: 108d77 [ 0.179] Detected LCD panel: acx565akm [ 0.183] DISPC: version 3.0 [ 0.187] LCD pixel clock 24000 kHz [ 0.218] Logo drawn in 5 ms (11700 kB/s) [ 0.333] Über-cool backlight fade-in took 9 ms [ 0.340] Initializing USB [ 0.348] No USB host detected [ 0.351] Loading kernel image info Loading kernel (1705 kB)... done in 61 ms (27612 kB/s) [ 0.422] Loading initfs image info [ 0.425] Total bootup time 429 ms [ 0.429] Serial console enabled Uncompressing Linux............................................................. ...................................................... done, booting the kernel.

[ 0.000000] Initializing cgroup subsys cpu [ 0.000000] Linux version 2.6.28-omap1 (bifh7@maemo-bifh-27) (gcc version 4.2 .1) #1 PREEMPT Thu Apr 15 09:47:09 EEST 2010 [ 0.000000] CPU: ARMv7 Processor [411fc083] revision 3 (ARMv7), cr=10c5387f [ 0.000000] CPU: VIPT nonaliasing data cache, VIPT nonaliasing instruction ca che [ 0.000000] Machine: Nokia RX-51 board [ 0.000000] Memory policy: ECC disabled, Data cache writeback [ 0.000000] OMAP3430 ES3.1 [ 0.000000] SRAM: Mapped pa 0x40200000 to va 0xe3000000 size: 0x100000 [ 0.000000] VRAM: 5357568 bytes at 0x8f578000. (Detected 868352 at 0x8f9c0000 ) [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pag es: 65024 [ 0.000000] Kernel command line: init=/sbin/preinit ubi.mtd=rootfs root=ubi0: rootfs rootfstype=ubifs rootflags=bulk_read,no_chk_data_crc rw console=ttyMTD,lo g console=tty0 snd-soc-rx51.hp_lim=42 snd-soc-tlv320aic3x.hp_dac_lim=6 [ 0.000000] Clocking rate (Crystal/DPLL/ARM core): 19.2/332/500 MHz [ 0.000000] Reprogramming SDRC [ 0.000000] GPMC revision 5.0 [ 0.000000] IRQ: Found an INTC at 0xd8200000 (revision 4.0) with 96 interrupt s [ 0.000000] Total of 96 interrupts on 1 active controller [ 0.000000] OMAP34xx GPIO hardware version 2.5 [ 0.000000] PID hash table entries: 1024 (order: 10, 4096 bytes) [ 0.000000] OMAP clockevent source: GPTIMER1 at 32768 Hz [ 0.000000] Console: colour dummy device 80x30 [ 0.000000] console [tty0] enabled [ 0.000000] Dentry cache hash table entries: 32768 (order: 5, 131072 bytes) [ 0.000000] Inode-cache hash table entries: 16384 (order: 4, 65536 bytes) [ 0.000000] allocated 1310720 bytes of page_cgroup [ 0.000000] please try cgroup_disable=memory option if you don't want [ 0.000000] Memory: 128MB 128MB = 256MB total [ 0.000000] Memory: 245052KB available (3220K code, 396K data, 144K init) [ 0.000000] SLUB: Genslabs=8, HWalign=64, Order=0-3, MinObjects=0, CPUs=1, No des=1 [ 0.000000] Calibrating delay loop... 499.92 BogoMIPS (lpj=1949696) [ 0.000000] Security Framework initialized [ 0.000000] Mount-cache hash table entries: 512 [ 0.000000] Initializing cgroup subsys memory [ 0.000000] Initializing cgroup subsys freezer [ 0.000000] CPU: Testing write buffer coherency: ok [ 0.000000] net_namespace: 448 bytes [ 0.000000] regulator: core version 0.5 [ 0.000000] NET: Registered protocol family 16 [ 1.248596] OMAP DMA hardware revision 4.0 [ 1.248687] Reserving DMA channels 0 and 1 for HS ROM code [ 1.249786] MUX: setup J21_34XX_I2C1_SDA (0xd80021bc): 0x0100 -> 0x0118 [ 1.249847] MUX: setup K21_34XX_I2C1_SCL (0xd80021ba): 0x0100 -> 0x0118 [ 1.249969] MUX: setup AE15_34XX_I2C2_SDA (0xd80021c0): 0x0100 -> 0x0118 [ 1.250030] MUX: setup AF15_34XX_I2C2_SCL (0xd80021be): 0x0100 -> 0x0118 [ 1.250152] MUX: setup AG14_34XX_I2C3_SDA (0xd80021c4): 0x0100 -> 0x0118 [ 1.250213] MUX: setup AF14_34XX_I2C3_SCL (0xd80021c2): 0x0100 -> 0x0118 [ 1.250671] USB: No board-specific platform config found [ 1.253814] i2c_omap i2c_omap.1: bus 1 rev3.12 at 2200 kHz [ 1.255187] TWL5030: Enabling workaround for rev 0x1009002F [ 1.271972] twl4030: PIH (irq 7) chaining IRQs 368..375 [ 1.272033] twl4030: power (irq 373) chaining IRQs 376..383 [ 1.272308] twl4030: gpio (irq 368) chaining IRQs 384..401 [ 1.273468] regulator: VDAC: 1800 mV normal standby [ 1.273803] regulator: VUSB1V5: 1500 mV normal standby [ 1.274169] regulator: VUSB1V8: 1800 mV normal standby [ 1.274536] regulator: VUSB3V1: 3100 mV normal standby [ 1.274871] i2c_omap i2c_omap.2: bus 2 rev3.12 at 100 kHz [ 1.275˜�