Editing Documentation/Maemo 5 Developer Guide/Development Environment/Maemo Flasher-3.5
Warning: You are not logged in.
Your IP address will be recorded in this page's edit history.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 1: | Line 1: | ||
The Maemo Flasher-3.5 tool is used to flash data to the Maemo device internal 256 MB of NAND, which is where the bootloader, kernel, and rootfs (all of which make up the operating system) are stored. For N900 it is also used to format and flash the eMMC internal storage card (32GB). Flasher-3.5 can be used to upgrade to a new firmware, wipe the Maemo device and start from scratch, flash certain specific components, or change a number of hardware flags. It also can load and start a kernel and auxiliary system to RAM, e.g for recovery purposes, see [http://wiki.meego.com/ARM/N900/Using_Rescue_Initrd] | The Maemo Flasher-3.5 tool is used to flash data to the Maemo device internal 256 MB of NAND, which is where the bootloader, kernel, and rootfs (all of which make up the operating system) are stored. For N900 it is also used to format and flash the eMMC internal storage card (32GB). Flasher-3.5 can be used to upgrade to a new firmware, wipe the Maemo device and start from scratch, flash certain specific components, or change a number of hardware flags. It also can load and start a kernel and auxiliary system to RAM, e.g for recovery purposes, see [http://wiki.meego.com/ARM/N900/Using_Rescue_Initrd] | ||
- | Maemo Flasher-3.5 Tools | + | Maemo Flasher-3.5 Tools can be downloaded from the [http://tablets-dev.nokia.com/maemo-dev-env-downloads.php Maemo Development Environment Downloads] page. |
== Release details == | == Release details == |
Learn more about Contributing to the wiki.