N900 FM radio transmitter
(fixed reference to driver docs) |
(→Features) |
||
(31 intermediate revisions not shown) | |||
Line 1: | Line 1: | ||
- | The | + | The N900 has a FM radio transmitter capable of sending audio several meters. |
- | + | ==Hardware== | |
- | + | ||
- | The | + | The SI4713 chip is used to transmit FM radio with radiotext in the range 76-108MHz from a digital or analog audio input. |
+ | |||
+ | === Features === | ||
+ | |||
+ | From the datasheet: | ||
+ | * Integrated receiver for receive power measurement | ||
+ | * Worldwide FM band support (76–108 MHz) for transmit | ||
+ | * Requires only two external components | ||
+ | * Frequency synthesizer with integrated VCO | ||
+ | * Digital stereo modulator | ||
+ | * Programmable pre-emphasis (50/75 µs) | ||
+ | * Analog/digital audio interface | ||
+ | * Programmable reference clock | ||
+ | * RDS/RBDS transmit encoder (Si4713 only) | ||
+ | * PCB loop antenna support with self calibrated capacitor tuning | ||
+ | * Programmable transmit level | ||
+ | * Programmable modulation | ||
+ | * 2.7 to 5.5 V supply voltage | ||
+ | * Digital gain compression | ||
+ | * Integrated LDO regulator | ||
+ | * 3 × 3 × 0.55 mm 20-pin QFN | ||
+ | * Pb-free and RoHS Compliant | ||
+ | |||
+ | It is short range only, see the section on [[#Typical Range|typical range]]. | ||
+ | |||
+ | It can also receive the signal level on the tuned frequency. This enables transmitter application to scan all frequencies, checking for vacant ones, and suggesting empty frequencies to the user for selection as transmission frequencies. | ||
+ | |||
+ | The [[Nokia N900|N900]] controls the FM transmitter through the I2C(2) bus, and supplies analog audio (same audio lines as HP-AMP) to the transmitter. The transmitter's digital audio inputs are unused (NC). | ||
The FM signal is transmitted from a loop antenna built into the case, and connected to the PCB with clips. | The FM signal is transmitted from a loop antenna built into the case, and connected to the PCB with clips. | ||
- | + | product marketing sheet: [http://www.silabs.com/Support%20Documents/TechnicalDocs/Si4712-13-B30.pdf Si4713] | |
+ | Full datasheet http://www.silabs.com/Support%20Documents/TechnicalDocs/AN332.pdf. | ||
The documentation for the driver, along with some information on the chip is at | The documentation for the driver, along with some information on the chip is at | ||
http://www.mjmwired.net/kernel/Documentation/video4linux/si4713.txt | http://www.mjmwired.net/kernel/Documentation/video4linux/si4713.txt | ||
- | + | It is connected to the [[N900 Hardware Bus I2C|I2C]] bus-2. | |
+ | ==Software== | ||
+ | ===Kernel=== | ||
+ | It is controlled through the kernel module fmtx_si4713, which implements the interfaces /dev/radio0 - a video4linux device. | ||
- | + | v4l2-ctl dumps the following information about the device. | |
- | + | v4l2-ctl --all -d /dev/radio0 | |
+ | Driver Info: | ||
+ | Driver name : radio-si4713 | ||
+ | Card type : Silicon Labs Si4713 FM Radio Tr | ||
+ | Bus info : I2C: 0x63 | ||
+ | Driver version: 1 | ||
+ | Capabilities : 0x00010000 | ||
+ | Tuner | ||
+ | Video input : 0 | ||
+ | Frequency: 1400000 (87.500000 MHz) | ||
+ | Video Standard = 0x00000000 | ||
+ | Streaming Parameters Video Capture: | ||
+ | Frames per second: 25.000 (25/1) | ||
+ | Read buffers : 0 | ||
+ | Tuner: | ||
+ | Name : FM Transmitter | ||
+ | Capabilities : 62.5 Hz stereo | ||
+ | Frequency range : 87.5 MHz - 108.0 MHz | ||
+ | Signal strength/AFC : 0%/0 | ||
+ | Current audio mode : stereo | ||
+ | Available subchannels: stereo | ||
- | |||
- | [http://www. | + | See [http://www.stanford.edu/~blp/fmtools/ for more information on the video4linux API]. |
+ | The driver also exposes the sysfs directory ./class/i2c-adapter/i2c-2/2-0063/ . | ||
- | + | ===User=== | |
- | The | + | The FM transmitter can be enabled in the settings application, and there are third party applications to more easily enable it. |
- | + | No software currently uses the ability of the chip to scan for free channels. | |
- | + | ||
+ | The package [http://maemo.org/packages/view/fm-boost/ FM boost] maximizes the transmitter power. In some cases, this may improve reception. In others, the transmitter will already be set to highest output. | ||
+ | |||
+ | There are several bugs open with regards the FM transmitter [https://bugs.maemo.org/show_bug.cgi?id=6792 this one] for example is regarding the policy to turn off the FM transmitter when the device is plugged into a computer using the USB cable. | ||
+ | |||
+ | The D-Bus interface is documented in [http://maemo.org/api_refs/5.0/5.0-final/fmtx-middleware/fmtx_api.html this page] | ||
+ | |||
+ | ==Typical Range== | ||
+ | |||
+ | Low power transmitters that are license compliant - do not exceed the regulations - are inherently short range devices and will have poor performance in many desired use-cases simply due to the regulatory limit on power usage. | ||
+ | |||
+ | In the US - the limit is approximately 15 nW, in the UK, 50 nW. | ||
+ | |||
+ | The below OFCOM document lists ranges to a good receiver with a fully extended antenna as 4m for 15nW and 8m for 50nW. (to achieve 'noiseless' reception) | ||
+ | |||
+ | [http://www.ofcom.org.uk/radiocomms/ifi/licensing/classes/rlans/technical/tests/srdtests.pdf This document from OFCOM (UK licensing agency) outlines test results for 50nW devices)] [http://www.ofcom.org.uk/consult/condocs/wtexemption/responses/bbc.pdf and this is a BBC response to the OFCOM proposal to legalise them in the UK]. Quoting the second: | ||
+ | :"The BBC appreciates the advantage in principle of authorising for licence-exempt use low-power Band II transmitters constructed strictly to a common European type-approval regime and ‘CE’ marked. | ||
+ | :However, the chosen maximum ERP of 50 nW is neither sufficiently small to avoid creating interference to broadcast reception nor sufficiently large to guarantee that such ‘Micro’ FM transmitters will actually work as intended in areas where Band II is utilised intensively, such as London." | ||
[[Category:N900]] | [[Category:N900]] | ||
[[Category:N900_Hardware]] | [[Category:N900_Hardware]] |
Latest revision as of 22:19, 5 January 2014
The N900 has a FM radio transmitter capable of sending audio several meters.
Contents |
[edit] Hardware
The SI4713 chip is used to transmit FM radio with radiotext in the range 76-108MHz from a digital or analog audio input.
[edit] Features
From the datasheet:
- Integrated receiver for receive power measurement
- Worldwide FM band support (76–108 MHz) for transmit
- Requires only two external components
- Frequency synthesizer with integrated VCO
- Digital stereo modulator
- Programmable pre-emphasis (50/75 µs)
- Analog/digital audio interface
- Programmable reference clock
- RDS/RBDS transmit encoder (Si4713 only)
- PCB loop antenna support with self calibrated capacitor tuning
- Programmable transmit level
- Programmable modulation
- 2.7 to 5.5 V supply voltage
- Digital gain compression
- Integrated LDO regulator
- 3 × 3 × 0.55 mm 20-pin QFN
- Pb-free and RoHS Compliant
It is short range only, see the section on typical range.
It can also receive the signal level on the tuned frequency. This enables transmitter application to scan all frequencies, checking for vacant ones, and suggesting empty frequencies to the user for selection as transmission frequencies.
The N900 controls the FM transmitter through the I2C(2) bus, and supplies analog audio (same audio lines as HP-AMP) to the transmitter. The transmitter's digital audio inputs are unused (NC).
The FM signal is transmitted from a loop antenna built into the case, and connected to the PCB with clips.
product marketing sheet: Si4713 Full datasheet http://www.silabs.com/Support%20Documents/TechnicalDocs/AN332.pdf.
The documentation for the driver, along with some information on the chip is at http://www.mjmwired.net/kernel/Documentation/video4linux/si4713.txt
It is connected to the I2C bus-2.
[edit] Software
[edit] Kernel
It is controlled through the kernel module fmtx_si4713, which implements the interfaces /dev/radio0 - a video4linux device.
v4l2-ctl dumps the following information about the device.
v4l2-ctl --all -d /dev/radio0 Driver Info: Driver name : radio-si4713 Card type : Silicon Labs Si4713 FM Radio Tr Bus info : I2C: 0x63 Driver version: 1 Capabilities : 0x00010000 Tuner Video input : 0 Frequency: 1400000 (87.500000 MHz) Video Standard = 0x00000000 Streaming Parameters Video Capture: Frames per second: 25.000 (25/1) Read buffers : 0 Tuner: Name : FM Transmitter Capabilities : 62.5 Hz stereo Frequency range : 87.5 MHz - 108.0 MHz Signal strength/AFC : 0%/0 Current audio mode : stereo Available subchannels: stereo
See for more information on the video4linux API.
The driver also exposes the sysfs directory ./class/i2c-adapter/i2c-2/2-0063/ .
[edit] User
The FM transmitter can be enabled in the settings application, and there are third party applications to more easily enable it.
No software currently uses the ability of the chip to scan for free channels.
The package FM boost maximizes the transmitter power. In some cases, this may improve reception. In others, the transmitter will already be set to highest output.
There are several bugs open with regards the FM transmitter this one for example is regarding the policy to turn off the FM transmitter when the device is plugged into a computer using the USB cable.
The D-Bus interface is documented in this page
[edit] Typical Range
Low power transmitters that are license compliant - do not exceed the regulations - are inherently short range devices and will have poor performance in many desired use-cases simply due to the regulatory limit on power usage.
In the US - the limit is approximately 15 nW, in the UK, 50 nW.
The below OFCOM document lists ranges to a good receiver with a fully extended antenna as 4m for 15nW and 8m for 50nW. (to achieve 'noiseless' reception)
This document from OFCOM (UK licensing agency) outlines test results for 50nW devices) and this is a BBC response to the OFCOM proposal to legalise them in the UK. Quoting the second:
- "The BBC appreciates the advantage in principle of authorising for licence-exempt use low-power Band II transmitters constructed strictly to a common European type-approval regime and ‘CE’ marked.
- However, the chosen maximum ERP of 50 nW is neither sufficiently small to avoid creating interference to broadcast reception nor sufficiently large to guarantee that such ‘Micro’ FM transmitters will actually work as intended in areas where Band II is utilised intensively, such as London."
- This page was last modified on 5 January 2014, at 22:19.
- This page has been accessed 83,476 times.