Root access
(→Securing root access: Removing user password section, as it's more likely to cause problems than anything and sudoers is a good way to reboot loop) |
(→Change root password) |
||
| Line 40: | Line 40: | ||
=== Change root password === | === Change root password === | ||
<small>''Note: The OpenSSH requires that the root password be set as part of its installation process, if you have installed OpenSSH you have already completed this step''</small> | <small>''Note: The OpenSSH requires that the root password be set as part of its installation process, if you have installed OpenSSH you have already completed this step''</small> | ||
| - | |||
| - | |||
| - | |||
| - | |||
To change root password (as root user): | To change root password (as root user): | ||
| Line 49: | Line 45: | ||
passwd | passwd | ||
| - | When asked, input | + | When asked, input your [http://en.wikipedia.org/wiki/Password_strength new password] twice. |
Revision as of 06:12, 1 July 2008
 |
This is an article from the old midgard wiki that hasn't yet been fully updated for this wiki, please update it. Please see the talk page for discussion. |
 |
Having root access is an important step for users interested in modifying their tablets as without it, you wont have the necessary permissions to make those modifications. Unfortunately, root access is disabled by default on new tablets. Thankfully, the steps to enable root access are simple.
Contents |
easyroot
Install easyroot from nitapps.com.
Then, from the shell, run root. This will give you a root shell.
OpenSSH
- Enabled Extras (if you haven't already).
- Install OpenSSH (client and server).
- SSH into your tablet as root
- For local access, run
ssh root@localhost - For remote access, run
ssh root@tablet's ip address
- For local access, run
- Use the root password that the OpenSSH package asked you to enter to log in (in ancient OS versions you had to use the factory default "rootme" password).
R&D Mode
Note: As R&D mode has other side effects beyond simply enabling root access (including several that can negatively impact battery life), it is not the recommended method for gaining root access. Use easyroot instead.
You can enable the Research & Development mode (R&D or RD mode, which enables you to execute sudo gainroot to get a root shell, simply follow the setup steps for flashing covered in Upgrading tablet OS, then execute
sudo ./flasher-3.0 --enable-rd-mode -r
You are now in R&D mode, and the sudo gainroot script's check will be satisfied.
Securing root access
At this point you should have gained root access to your device, and be looking at the root prompt:
#
However, if your Wi-Fi network is not password protected, so might anyone else near you who has Wi-Fi, SSH and a clue.
You still need to secure the root account ("rootme" is a terrible password).
Change root password
Note: The OpenSSH requires that the root password be set as part of its installation process, if you have installed OpenSSH you have already completed this step
To change root password (as root user):
passwd
When asked, input your new password twice.