N900 LCD panel
(New page: The LCD is the display of the N900. It has a resistive touchscreen on top. ==Hardware== ==Software==) |
(→Hardware: PWM) |
||
(6 intermediate revisions not shown) | |||
Line 1: | Line 1: | ||
- | The LCD is the display of the N900. It has a resistive touchscreen on top. | + | The LCD is the display of the [[Nokia N900|N900]]. It has a resistive touchscreen on top. |
+ | |||
==Hardware== | ==Hardware== | ||
+ | |||
+ | The main display is a ACX565AKM LCD panel, manufactured by Sony. | ||
+ | |||
+ | The pinout for the LCD Panel's connector is: | ||
+ | |||
+ | 1 LED2+ | ||
+ | 2 LED1+ | ||
+ | 3 GND | ||
+ | 4 Data0- | ||
+ | 5 Data0+ | ||
+ | 6 Clock- | ||
+ | 7 Clock+ | ||
+ | 8 Data1- | ||
+ | 9 Data1+ | ||
+ | 10 GND | ||
+ | 11 Touch Y- | ||
+ | 12 Touch X+ | ||
+ | 13 Touch Y+ | ||
+ | 14 Touch X- | ||
+ | 15 SCLK | ||
+ | 16 RESET | ||
+ | 17 MOSI | ||
+ | 18 MISO | ||
+ | 19 CS2 | ||
+ | 20 V18( 1.8V Supply ) | ||
+ | 21 V28( 2.8V Supply ) | ||
+ | 22 CABC | ||
+ | 23 LED1- | ||
+ | 24 LED2- | ||
+ | Shield GND | ||
+ | |||
+ | CABC is a PWM output line which gets or'ed with the LCD_LEDS signal from GAIA and fed to the EN pin of the backlight driver to control backlight brightness. | ||
+ | |||
+ | Pin 15, 17, 18 and 19 are a SPI interface. | ||
+ | |||
+ | Pins 11 thru 14 are connected to the touch panel connector on the LCD flatcable. | ||
+ | |||
==Software== | ==Software== | ||
+ | |||
+ | [[Category:N900 Hardware]] |
Latest revision as of 16:23, 20 October 2014
The LCD is the display of the N900. It has a resistive touchscreen on top.
[edit] Hardware
The main display is a ACX565AKM LCD panel, manufactured by Sony.
The pinout for the LCD Panel's connector is:
1 LED2+ 2 LED1+ 3 GND 4 Data0- 5 Data0+ 6 Clock- 7 Clock+ 8 Data1- 9 Data1+ 10 GND 11 Touch Y- 12 Touch X+ 13 Touch Y+ 14 Touch X- 15 SCLK 16 RESET 17 MOSI 18 MISO 19 CS2 20 V18( 1.8V Supply ) 21 V28( 2.8V Supply ) 22 CABC 23 LED1- 24 LED2- Shield GND
CABC is a PWM output line which gets or'ed with the LCD_LEDS signal from GAIA and fed to the EN pin of the backlight driver to control backlight brightness.
Pin 15, 17, 18 and 19 are a SPI interface.
Pins 11 thru 14 are connected to the touch panel connector on the LCD flatcable.
[edit] Software
- This page was last modified on 20 October 2014, at 16:23.
- This page has been accessed 12,358 times.