Nitdroid easy install on EMMC

Image:Ambox_notice.png
Some instructions here may cause serious problems. When unsure, see General precautions
Backing up your data is recommended. In case of trouble you might need to re-flash your device.


Image:Ambox_notice.png
Under heavy construction

Original Talk Maemo thread:

http://talk.maemo.org/showpost.php?p=887394&postcount=1


Contents

Installing NITDroid

This tutorial is specifically designed to install Nitdroid on the internal memory of the N900 (EMMC) and does not apply to installation on an external micro SD card. The main purpose of installing Nitdroid on the internal memory is that in most cases you will see an increased performance.

There are two ways of installing NITDroid:

1. Copy NITDroid's rootfs to /and in /home: Easier - Faster

2. Creating a custom 2GB partition on your eMMC: Cleaner - Requires a brain


Method 1

NOTE: It is highly recomended that you flash the modded 8GB 20GB eMMC image. Nitdroid won't recognize/use/install anything if you have low memory in mmcblk0p2.

Clean Installing of NITDroid

  1. Download the archive + the kernel to /MyDocs i.e. root dir. of N900:
  2. Enable all repositories from App manager (Extras-testing, Extras-devel, Extras and the default Nokia repos)

  1. Install Leafpad from the App manager and make sure that you have root access
  2. Close App manager, open X Terminal and execute the following commands:
    root
    apt-get update
    apt-get install nitdroid-installer
    y
    y again if it asks again.
    
  3. After the nitdroid-installer package is installed, close X Terminal, but do NOT run the installer you have just downloaded.
  4. Open X Terminal, and execute the following commands:
    root
    cd /home/user/MyDocs
    bzip2 -d nitdroidarchivename.tar.bz2
    

    (You can only uncompress the file once. So only do this step once!)

  5. Open X Terminal (or use the same xterm as you used for the previous step), and execute the following commands:
    cd /home
    mkdir /and
    cd /
    mount /home /and
    cd /and
    tar xvf /home/user/MyDocs/nitdroidarchivename.tar
    dpkg -i /home/user/MyDocs/nitdroid-kernel-2.6.28-07_rc4_armel.deb
    
  6. Edit the boot file:
    leafpad /etc/multiboot.d/11-NITDroid-mmcblk0p2-2.6.28.NIT.06.item

    (then tap the tab button, .item file will show, hit enter to open it in Leafpad).

    Edit ITEM_DEVICE in the file according to this:

    • If you have an MMC (micro SD card) plugged in your N900, change ITEM_DEVICE to this:
      ITEM_DEVICE=${INT_CARD}p2
      
    • If you don't have an MMC plugged in your N900, change ITEM_DEVICE to this:
      ITEM_DEVICE=mmcblk0p2
      
  7. Once editing is complete click the drop down menu on Leafpad and save then close Leafpad.
  8. Close X Terminal, reboot N900 and type ‘2’ for NITDroid.

    You can now start using Nitdroid

Upgrading from Previous Versions of NITDroid

Note: CLEAN INSTALL IS HIGHLY RECOMMENDED. You have been warned.

  1. Download the image + the kernel to /MyDocs i.e. root dir. of N900:

    Open X Terminal, and execute the following commands:
    root
    cd /home/user/MyDocs
    bzip2 -d Nitdroidarchivename.tar.bz2
    cd /
    mount /home /and
    cd /and
    tar xvf /home/user/MyDocs/Nitdroidarchivename.tar
    dpkg -i /home/user/MyDocs/nitdroid-kernel-2.6.28-07_rc4_armel.deb
    


Reference Installation Videos:

    Reference installation video: http://www.youtube.com/watch?v=Bm6spW5yadk
    Reference installation video (version 2, using N11 "Vostok"): http://www.youtube.com/watch?v=uMHxo1ALXNE

Method 2

As said before, this requires a brain and a bit of concentration, follow step-by-step, and use some logic.

NOTE: This will wipe all of your data, please BACKUP necessary data first.

  1. Download the archive + the kernel + Fdisk to /MyDocs i.e. root dir. of N900:
  2. Enable all repositories from App manager (Extras-testing, Extras-devel, Extras and the default Nokia repos)

  1. Install Fdisk by executing the following commands in Xterminal:
    root
    mkdir -p /home/user/util-linux /home/user/bin
    cp /home/user/MyDocs/util-linux_2.13.1.1-1_armel.deb /home/user/util-linux
    cd /home/user/util-linux
    dpkg-deb -x util-linux_2.13.1.1-1_armel.deb root
    cp root/sbin/fdisk /home/user/bin/
    cd ..
    rm -rf util-linux
    
  2. Unmount designated partition (./MyDocs):
    umount /home/user/MyDocs
    
  3. Launch Fdisk:
    /home/user/bin/fdisk /dev/mmcblk0
    
  4. Print your current partition table:
    p 
    

    This table should show up:

           Device Boot      Start         End      Blocks   Id  System
    /dev/mmcblk0p1               2      884865    28315648    c  W95 FAT32 (LBA)
    /dev/mmcblk0p2          884866      950401     2097152   83  Linux
    /dev/mmcblk0p3          950402      974977      786432   82  Linux swap / Solaris
    
  5. Delete partition 1 (./MyDocs):
    d
    1
    
  6. Create new re-sized primary partition:
    n
    p
    1
    First cylinder: 2
    Last cylinder: 800000
    
  7. Create new extended partition:
    n
    e
    First cylinder: 800001
    Last cylinder: 884865
    n
    First cylinder: 800001
    Last cylinder: 884865
    t
    1
    76
    t
    5
    76
    
  8. Point of no return - writing the table and syncing:
    w
    reboot
    
  9. After the reboot, return ./MyDocs back and format the new NITDroid partition by executing these:
    root
    /home/user/bin/fdisk /dev/mmcblk0
    t
    1
    0c
    w
    mkfs.vfat -F 32 /dev/mmcblk0p1
    mke2fs -L NITDroid -j -m0 /dev/mmcblk0p5
    reboot
    

    If your device still has a flash memory on it, then lift your shoulders up as the hard part is gone!

  10. Install Nitdroid on the new partition:
    apt-get update
    apt-get install nitdroid-installer
    mkdir -p /and
    mount -o noatime,rw /dev/mmcblk0p5 /and
    cd /home/user/MyDocs
    rm -rf /and/*
    bzcat Nitdroidarchivename.tar.bz2 | tar xvC /and
    dpkg -i nitdroid-kernel-2.6.28-07_rc4_armel.deb
    reboot
    

Fixes

Some simple fixes of NITDroid included here:

Not charging

In NITDroid, go to:

App drawer --> Settings --> Applications --> Development --> Stay awake

This should let the screen stay awake while charging, your device will be charging normally.

Google account sign-in

Skip google sign-up in the first tutorial instead, sign up/in google once in NITDroid.

Overclocking NITDroid

1. You can download ready GUI's from the market for OCing: http://talk.maemo.org/attachment.php?attachmentid=16607&d=1293643705

NOTE: Recommended settings for Setcpu: Min:125 Max:805 Governor:Conservative

2. Or use one of these profiles: http://forum.nitdroid.com/index.php?topic=116.0

Kernel Power installation

For kernel-power multiboot entry: http://www.mediafire.com/?t3mdemq1hj7v5ur

1. Unrar this archive to ./MyDocs, then:

2. On Xterminal, execute:
root
mount /home /and
dpkg -i /home/user/MyDocs/multiboot-0.2.11-kernel-power-46-Android-Kernel/*

3. Reboot your device, you shall see a new multiboot entry for kernel-power.

Custom EMMCs

Just in case you fear to run out of memory, here are custom EMMCs if you want to reflash:

5GB app memory 24GB /MyDocs: http://www.mediafire.com/?j6srnaxwr3notaf

and/or

8GB app memory 21GB /MyDocs: http://www.mediafire.com/?5o1hkuuwhn8hh1c

Uninstalling NITDroid

Method 1

Open X Terminal and type the following commands:

root
mount /dev/mmcblk0p2 /and -o noatime
nitdroid-uninstaller

After it completes, using filebox, delete nitdroid's installation folders and files that were copied to home: bin, data, dev, etc (symlink), initrd, lib (symlink), mnt, proc, sbin, sdcard, sys, system, tmp, usr,default.prop, init, init.nokia.rc, init.rc

Method 2

Open X Terminal and type the following commands:

root
mount -o noatime,rw /dev/mmcblk0p5
rm -rf /and/*

Then uninstall multiboot by anyway you prefer.

Videos of NITDroid running on EMMC

My video: http://www.youtube.com/watch?v=l_9kG81m-S4

Mr.NokiaTecs' video: http://www.youtube.com/watch?v=z7MIGu2POzY

Nokiatolo: http://www.youtube.com/watch?v=KYmOpftdtqg

Warlord1994's video: http://www.youtube.com/watch?v=UCVAho3_rDM