Editing R&D mode
Warning: You are not logged in.
Your IP address will be recorded in this page's edit history.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 17: | Line 17: | ||
== R&D mode flags == | == R&D mode flags == | ||
- | You can enable some R&D mode flags (<code>flasher-3.5 --set-rd-flags=''<flag>''</code>) for various features: | + | You can enable some R&D mode flags (<code>flasher-3.5 --set-rd-flags=''<flag>''</code>) for various features (this is N8x0 below): |
- | |||
- | |||
*<code>no-lifeguard-reset</code> - Disables the lifeguard process (lifeguard reboots the device when an important system process crashes). | *<code>no-lifeguard-reset</code> - Disables the lifeguard process (lifeguard reboots the device when an important system process crashes). | ||
*<code>serial-console</code> - Enables the serial console (the serial port pins are next to the battery) and causes a shorter battery life. | *<code>serial-console</code> - Enables the serial console (the serial port pins are next to the battery) and causes a shorter battery life. | ||
+ | *<code>no-omap-wd</code> - Disables the watchdog on the OMAP processor. | ||
+ | *<code>no-retu-wd</code> - Disables the watchdog on retu. | ||
*<code>no-usb-timeout</code> - Unknown | *<code>no-usb-timeout</code> - Unknown | ||
- | |||
*<code>no-charging</code> - Disables charging via the USB port. bme will still be running in the background. | *<code>no-charging</code> - Disables charging via the USB port. bme will still be running in the background. | ||
- | |||
running the command without parameters gives a list of available modes: | running the command without parameters gives a list of available modes: | ||
Line 46: | Line 44: | ||
</pre> | </pre> | ||
- | It seems enabling of R&D mode is causing device ( | + | It seems enabling of R&D mode is causing device (N900) to power up on battery insert and USB-connect, and possibly force-power-key can restore the "usual" behaviour ((confirmation needed)) |
- | + | ||
- | + | ||
[[Category:Power users]] | [[Category:Power users]] |
Learn more about Contributing to the wiki.