N900 Hardware Hacking/serial dump

NOLO X-Loader (v1.4.14, Apr 22 2010)
Secondary image size 109384
Booting secondary
[   0.002] Nokia OMAP Loader v1.4.14 (Apr 22 2010) running on Nokia N900 F5 (RX-51)
[   0.014] I2C v3.12
[   0.033] System DMA v4.0
[   0.036] OneNAND device ID 0040, version ID 0121 (256 MiB, 66 MHz)
[   0.071]   OneNAND blocks unlocked in 28052 us
[   0.075]   Flash id: ec4021
[   0.094] Partition table successfully read
[   0.102] TWL4030 PWR ISR: 40
[   0.105] Reset reason: por
[   0.107] McSPI v2.1
[   0.111] LP5523 found at I2C bus 2, address 0x32
[   0.121] SMB138C: Not loading driver (version reg. 0x4b)
[   0.127] BQ24150 (rev. 3) found on I2C bus 1, address 0x6b
[   0.133] SSI version 1.0
[   0.147] Battery voltage 3.436 V, BSI: 0
[   0.157] Disabling charging (no battery present)
[   0.169] Initializing LCD panel
[   0.172]   Detecting LCD panel moscow
[   0.176]     Panel ID: 108d77
[   0.179]   Detected LCD panel: acx565akm
[   0.183] DISPC: version 3.0
[   0.187]   LCD pixel clock 24000 kHz
[   0.218]   Logo drawn in 5 ms (11700 kB/s)
[   0.333]   Über-cool backlight fade-in took 9 ms
[   0.340] Initializing USB
[   0.348]   No USB host detected
[   0.351] Loading kernel image info
Loading kernel (1705 kB)... done in 61 ms (27612 kB/s)
[   0.422] Loading initfs image info
[   0.425] Total bootup time 429 ms
[   0.429] Serial console enabled
Uncompressing Linux.............................................................
...................................................... done, booting the kernel.

[    0.000000] Initializing cgroup subsys cpu
[    0.000000] Linux version 2.6.28-omap1 (bifh7@maemo-bifh-27) (gcc version 4.2.1) #1 PREEMPT Thu Apr 15 09:47:09 EEST 2010
[    0.000000] CPU: ARMv7 Processor [411fc083] revision 3 (ARMv7), cr=10c5387f
[    0.000000] CPU: VIPT nonaliasing data cache, VIPT nonaliasing instruction cache
[    0.000000] Machine: Nokia RX-51 board
[    0.000000] Memory policy: ECC disabled, Data cache writeback
[    0.000000] OMAP3430 ES3.1
[    0.000000] SRAM: Mapped pa 0x40200000 to va 0xe3000000 size: 0x100000
[    0.000000] VRAM: 5357568 bytes at 0x8f578000. (Detected 868352 at 0x8f9c0000)
[    0.000000] Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 65024
[    0.000000] Kernel command line: init=/sbin/preinit ubi.mtd=rootfs root=ubi0:rootfs rootfstype=ubifs rootflags=bulk_read,no_chk_data_crc rw console=ttyMTD,log console=tty0 snd-soc-rx51.hp_lim=42 snd-soc-tlv320aic3x.hp_dac_lim=6
[    0.000000] Clocking rate (Crystal/DPLL/ARM core): 19.2/332/500 MHz
[    0.000000] Reprogramming SDRC
[    0.000000] GPMC revision 5.0
[    0.000000] IRQ: Found an INTC at 0xd8200000 (revision 4.0) with 96 interrupts
[    0.000000] Total of 96 interrupts on 1 active controller
[    0.000000] OMAP34xx GPIO hardware version 2.5
[    0.000000] PID hash table entries: 1024 (order: 10, 4096 bytes)
[    0.000000] OMAP clockevent source: GPTIMER1 at 32768 Hz
[    0.000000] Console: colour dummy device 80x30
[    0.000000] console [tty0] enabled
[    0.000000] Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
[    0.000000] Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
[    0.000000] allocated 1310720 bytes of page_cgroup
[    0.000000] please try cgroup_disable=memory option if you don't want
[    0.000000] Memory: 128MB 128MB = 256MB total
[    0.000000] Memory: 245052KB available (3220K code, 396K data, 144K init)
[    0.000000] SLUB: Genslabs=8, HWalign=64, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[    0.000000] Calibrating delay loop... 499.92 BogoMIPS (lpj=1949696)
[    0.000000] Security Framework initialized
[    0.000000] Mount-cache hash table entries: 512
[    0.000000] Initializing cgroup subsys memory
[    0.000000] Initializing cgroup subsys freezer
[    0.000000] CPU: Testing write buffer coherency: ok
[    0.000000] net_namespace: 448 bytes
[    0.000000] regulator: core version 0.5
[    0.000000] NET: Registered protocol family 16
[    1.248596] OMAP DMA hardware revision 4.0
[    1.248687] Reserving DMA channels 0 and 1 for HS ROM code
[    1.249786] MUX: setup J21_34XX_I2C1_SDA (0xd80021bc): 0x0100 -> 0x0118
[    1.249847] MUX: setup K21_34XX_I2C1_SCL (0xd80021ba): 0x0100 -> 0x0118
[    1.249969] MUX: setup AE15_34XX_I2C2_SDA (0xd80021c0): 0x0100 -> 0x0118
[    1.250030] MUX: setup AF15_34XX_I2C2_SCL (0xd80021be): 0x0100 -> 0x0118
[    1.250152] MUX: setup AG14_34XX_I2C3_SDA (0xd80021c4): 0x0100 -> 0x0118
[    1.250213] MUX: setup AF14_34XX_I2C3_SCL (0xd80021c2): 0x0100 -> 0x0118
[    1.250671] USB: No board-specific platform config found
[    1.253814] i2c_omap i2c_omap.1: bus 1 rev3.12 at 2200 kHz
[    1.255187] TWL5030: Enabling workaround for rev 0x1009002F
[    1.271972] twl4030: PIH (irq 7) chaining IRQs 368..375
[    1.272033] twl4030: power (irq 373) chaining IRQs 376..383
[    1.272308] twl4030: gpio (irq 368) chaining IRQs 384..401
[    1.273468] regulator: VDAC: 1800 mV normal standby
[    1.273803] regulator: VUSB1V5: 1500 mV normal standby
[    1.274169] regulator: VUSB1V8: 1800 mV normal standby
[    1.274536] regulator: VUSB3V1: 3100 mV normal standby
[    1.274871] i2c_omap i2c_omap.2: bus 2 rev3.12 at 100 kHz
[    1.275˜�